FLOWX E-mail sales@flowxvalve.com

FLOWX Engineer 86-21-54150349

News

Home >> News >> Industry dynamics >> What Is Plastic Valves Replacement Period

What Is Plastic Valves Replacement Period

Source:http://www.flowxgroup.com/Update Time:2014-07-04Hits:

Polyvinyl chloride, or PVC, is one of the most well-known materials chosen for water pipes because it is cheap, sanitary and durable. PVC is also simple to turn with. It's not much more complex than wood, so you can cut the pipes with a handsaw. The pipes are linked with glue that sectional dissolves the plastic to constitute a permanent joint. Once PVC pipes are glued as one, however, you can't separate them. If it is necessary to substitute a component in a PVC waterline, like a valve, a replacement should be glued on. What is plastic valves replacement period and how to replace plastic valves replacement?

Turn off the water to the line that provides the electric actuators valve you want to replace. Unless there is another valve in down the line from the one you're changing, you'll have to shut off the home's prime water supply.

Cut through the pipe about two to four inches away from one link of the electric actuators valve, using a handsaw or hacksaw. Have a bucket handy to seize water as it spills out of the cut pipe.

Cut through the pipe about the same distance from the other connection of the electric actuators valve. Remove the valve.

We should sand the cut ends of the pipes with wet/dry sandpaper so that the burrs can be removed; any burrs will avoid the new accessories from jointing properly. You don't have to wait for the pipes to dry -- the glue will keep firm, even if a little water is existed.

Hold a PVC coupling near to the end of one pipe. Spread PVC cement freely on the end of the pipe and inside one end of the coupling, using the brush that comes in the can of cement. Make sure the glue contains the whole circumference of the pipe and the coupling.

Rapidly slide the glued coupling onto the pipe. Push it onto the pipe until the pipe is finished "seated" -- when it stays at a ridge inside the coupling. Glue a coupling onto the end of the other cut pipe in the same methods.

Cut a short length of PVC pipe that will expand entirely into one coupling and extrude about two inches. Glue the pipe to the coupling, using the same technique as before. Glue the electric pneumatic actuators valve onto the other end in the same approach.

Cut another length of pipe that will stretch out two inches into the other coupling and two inches into the other side of the valve. Glue it to the coupling. You will have to curve one of the lines to get the electric actuators valve out of the way, but it should be simple unless the line is very short.

Expand glue on the remaining end of the pipe and inside the electric actuators valve. Bend one of the stripes until you can insert the pipe into the valve. Release the stripe; the pipe should slide into the opening and seat inside the valve. This is plastic valves replacement period and how to replace plastic valves replacement.

Featured Products: diaphragm actuator | FLOWX Filter Regulator

Customer Hotline:
021-54150349