FLOWX E-mail sales@flowxvalve.com

FLOWX Engineer 86-21-54150349

News

Home >> News >> Industry dynamics >> The Introduction of Electric Actuators Component

The Introduction of Electric Actuators Component

Source:http://www.flowxgroup.com/Update Time:2014-06-25Hits:

Components of a Pneumatic System

Electric actuators systems vary from simple air-driven pistons to multiple-actuator mining running. All Electric actuators systems utilize condensed air to energy moving parts, or actuators. Electric actuators systems often take advantage of compressed atmospheric air, as it is affluent and inexpensive. Atomized oil is added to the air in some mixtures to alleviate its passage through mechanical systems. Generally, actuators systems favor over alike, liquid-using hydraulic systems, because of their calmness, ease of use and cost efficiency. The electric actuators components are described below.

Compressor

A compressor of electric actuators component is a pump powered by electricity or gas. This pump condenses the air to a higher PSI (pounds per square inch). Compressors may have a tank linked to reserve the air before it's discharged into the pneumatic track.

Regulators and Gauges

Regulators and gauges of electric actuators component are devices linked to the compressor or compressor tank. The regulator is either mechanically or electrically stroke to discharge air into the pneumatic track. Gauges are mechanic or electric measuring devices. They permit the operator or computer system to inspect and adjust the PSI of the air inside the compressor.

Check Valve

Check valves of electric actuators component are one-way valves that are installed to the hose linking the compressor or compressor tank to the buffer tank. They permit the compressed air to scrape up in the buffer tanks, but do not admit backflow into the compressor or compressor tank.

Buffer Tank or Accumulator

Buffer tanks are secondary reservation units for the compressed air stemming from the compressor. They reserve the high-PSI compressed air for ultimate use with the actuators. These tanks aid to hold back uneven airflow surges in the actuators; permit the compressor cycle to maximize its shutoff timing; and admit the compressor to be farther from the pneumatic actuators in projects where this interval is useful or necessary.

Feed Lines

Feed lines of electric actuators component are hoses that pass pressurized air through the electric actuators system. The largest diameter hoses that can manage the PSI the system used are installed. Large diameter hoses admit the pressurized air to go quickly, eliminating airflow backups.

Directional Valves

Directional valves of electric actuators component are put before electric actuators. Multiple-valve systems are mounted on projects with multiple actuators to power. Directional valves accept input from mechanical or electrical control sources. They re-direct, prevent or release the pressurized air to its suitable actuators at the times desired. Directional valves can be caused by the action of a button, spring, lever, pedal, solenoid or other device.

Actuators

An actuator is the electric actuators component that does the work. There are a wide range of actuators, powered by pressurized air. The pressurized air is emitted into the cylinder to move a piston forward as the air is pushed into the chamber. Instances of actuators of electric actuators component at work are air-powered instruments in building and dentistry.

Featured Products: metal sealing butterfly valve | metallic hard seal butterfly valve

Customer Hotline:
021-54150349