FLOWX E-mail sales@flowxvalve.com

FLOWX Engineer 86-21-54150349

News

Home >> News >> Industry dynamics >> Pneumatic Actuators to Reduce Power Consumption

Pneumatic Actuators to Reduce Power Consumption

Source:http://www.flowxgroup.com/Update Time:2014-04-18Hits:

In general, pneumatic actuators manufacture is wirelessly controlled and accomplished with the ultra low power consumption. This kind of hardware design allows super capacitors to offer constant power supply for longer periods even when the synchronization period and the duty cycle of pneumatic actuators manufacture in the end application. The use of pneumatic actuators manufacture with almost no degradation can help to eliminate the need for batteries replacement over time and the employment of a very precise synchronization method of less than ten seconds has been designed to make use of a low frequency crystal as well as divider that allows the pneumatic actuators manufacture to shut down most of peripheral devices so as to remarkably reduce the power consumption.

As a matter of fact, pneumatic actuators can be used in a number of synchronization protocols in order to reduce the messaging traffic and to improve accuracy as long as the pneumatic actuators can be used to open or close the valves that control the water of the pneumatic actuators producing plants. To be more specific, each pneumatic actuators solenoid should be connected to a node that could be wirelessly and independently controlled so that in the future, data can be collected in an easy manner in a real scenario and the pneumatic actuators system could be adapted for measuring to keep track of the consumed electrical energy and to transmit the data out to a central station.

In other words, the flux in the opposite direction of permanent pneumatic actuators magnet is designed to release the armature while the negative voltage within the device is reversely controlled from the neutral position since a flux can be created in the same direction as the permanent magnet flux to overcome the pneumatic actuators spring force catch armature. Comparing the conventional pneumatic actuators, the new design is marked by high voltage that is required by so as to release the armature and to perform the same work in more efficient way. Therefore, this shows clearly that the new design is more cost effective in term of energy consumption and this significant energy reduction due to the shorted turn is well placed in the current of pneumatic actuators coil to reduce the inductance. In fact, pneumatic actuators new design is proposed to overcome the inherent drawbacks of relatively large power consumption in conventional pneumatic actuators type. And when it comes to the evaluation of the performances of the proposed pneumatic actuators system and compare with conventional one, the new system has much smaller power consumption and is thus suitable for a wide range of application.

Featured Products: electric actuators | plastic ball valve

Customer Hotline:
021-54150349