FLOWX E-mail sales@flowxvalve.com

FLOWX Engineer 86-21-54150349

News

Home >> News >> Industry dynamics >> Pneumatic Actuators Optimize the Duty Cycles of Actuators Applications

Pneumatic Actuators Optimize the Duty Cycles of Actuators Applications

Source:http://www.flowxgroup.com/Update Time:2014-04-14Hits:

Limit switch user can solve a lot of problem under the pneumatic actuators protocol and is able to determine when to enable the transceiver in spite of the fact that there must be synchronization between more than five pneumatic actuators. What is more, limit switch users must also take into account the time when an array of pneumatic actuators nodes needs to transmit the signal information once at a time to avoid signal collisions, which is especially true when a node wants to transmit data. In general, the magnetic field of the pneumatic actuators can be analyzed with the help of a symmetric model via an analytical approach.

Therefore, the limit switch user magnetic field distribution can be figured out in the cross section that is laid for both static and dynamic design according to the requirements of the magnetic circuit as well as those of the mechanical strengths. From the perspective of pneumatic actuators systematic procedure, the choice of pneumatic actuators material in different applications should be given careful thought since the performance of the pneumatic actuators partly depends on the magnetic properties of the material of various components and the major approach to energy saving is achieved by the transceiver. For example, a type of pneumatic actuators transceiver used in the node consumes more energy in transmission as well as in the power down mode and the micro processor can be waked up from the sleep mode before any action is ordered from the control center.

In addition, it is also desirable for other pneumatic actuators devices such as sensors and actuators to be activated when they are needed, leading to the typical duty cycles of low power pneumatic actuators networks applications. This is mainly because in the active mode, the pneumatic actuators node will perform tasks such as sensing while in sleep mode the unused devices will be turned off for the consideration of more simplicity and energy efficiency since the pneumatic actuators processor and the sensors may have the same activation period as a result in the lower duty cycle with less energy consumption. At the same time, there are mainly three sections in the pneumatic actuators including the supply circuit panel, a cost effective capacitor and highly efficient converters that are powered by micro controller and transceiver in the control circuit because the converter is comprised of a valve with electric supply under the micro diagram module. In terms of the limit switch user terminal node, limit switch user needs to make use of an array of power circuits and micro controllers that are built in the system since it is designed on the basis of dimensional field requirements.

And you should know by doing so, different handwheel development trend nodes can communicate with each other in a more efficient manner since they enable their signal receivers within the same period of time to work at the transmission mode.

Featured Products: electric actuators | piezoelectric actuator

Customer Hotline:
021-54150349