FLOWX E-mail sales@flowxvalve.com

FLOWX Engineer 86-21-54150349

News

Home >> News >> Industry dynamics >> Pneumatic Actuator Node in the Output Port

Pneumatic Actuator Node in the Output Port

Source:http://www.flowxgroup.com/Update Time:2014-06-12Hits:

Both energy saving and smoothness must be taken into consideration when we are choosing which type of pneumatic actuators to buy. In order to carry out a simple pneumatic actuators experiment, motes might be used with an occupancy sensor. According to scientific research results, each pneumatic actuator node’s sampling time can be two seconds at most and its neighboring nodes are in general fixed regardless of the wireless PC ball valve communication range. It is a truth universally acknowledged that all pneumatic actuators nodes are assumed to have a light control unit with a digital output port in the overall setup so that the detected presence of people can communicate their signals to the neighboring PC ball valve nodes in less than five seconds.

In the case of the resulting PC ball valve control signals using the function method, there are more than fifty communication iterations if we evaluate and propose decentralized pneumatic actuators algorithm. Next, to be more specific, it is essential to develop a test bed for pneumatic actuators based on motes since the actuator node mainly consists of micro controller and occupancy sensor for the sake of remote control. The micro controller is used to drive the IR pneumatic actuators, so that remote control signals for lights can be generated. The light has an IR detector for reading the pneumatic actuators control signals and the lighting brightness can vary by eight magnitudes depending on the control signals.

In this pneumatic actuators experiment, more than three lights are deployed on the ceiling and three corresponding nodes are placed on the desk so that the pneumatic actuators can directly control the brightness of a unique light right above it. The pneumatic actuators wireless communication range is limited to approximately three meters in the pneumatic or electric actuators distributed lighting experiment. First, the three pneumatic actuators nodes detected the exact number of people and set the corresponding PC ball valve lights at maximum brightness and when the two people have left their desks, the nodes can soon detect the PC ball valve occupancy changes and begin to compute the optimal brightness by communicating with each other.

The pneumatic actuators nodes in general adjust the lights every interval, which means a communication and control duration of fifty seconds can be expected. Other pneumatic actuators experiments are also conducted with the help of the decentralized and centralized algorithms, which provide an exact PC ball valve solution for modified equation by the function method. This results in smart illumination in unpopulated areas close to an area where people are present thanks to the pneumatic actuators decentralized algorithm. The initial values of the calculated pneumatic actuators control signals are mainly determined by sensor responses.

Featured Products: FLOWX Handwheel | FLOWX Solenoid valve

Customer Hotline:
021-54150349