FLOWX Engineer 86-21-54150349
In the fluid piping system, valves are control components, its main function is to isolate equipment and piping system, regulating flow, preventing backflow, and discharging pressure. So far, valve industry has been able to produce all kinds of gate valve, cut-off valve, throttle valve, plug valves, pneumatic actuators, electric valve, diaphragm valve, check valve, safety valve, relief valve, steam trap and emergency cut-off valve and so on 12 major categories, more than 3000 models, more than 4000 specifications of the products; Its maximum working pressure of 600 mpa, the maximum nominal diameter is 5350 mm, the highest working temperature is 1200 ℃, the lowest working temperature is 196 ℃. The suitable medium is water, steam, oil, natural gas, strong corrosive medium, (such as nitric acid, concentration of sulfuric acid, etc.).
If you are an electric actuator supplier, we need to know follow 13 matters:
B) We must first make sure the electric actuator and the downstream piping have indeed unloaded the pressure, and then we can carry out dismantling operations.
C) When the sealing surface of the parts during decomposition and assembly, we must be careful to prevent injury especially non-metal parts, we need to use special tools to remove O-rings.
D) If you are an electric actuator supplier and you want to take use of the electric actuator advantages, the flange bolts must be symmetrical
E) Unlike electric actuators, you must first find out on the electric actuator, the downstream piping have indeed unloaded the pressure, and then you can carry out dismantling operations.
F) During decomposition and assembly again for the sealing surface of the parts, you must be careful to prevent injury especially electric actuators, you need to use of special tools to remove O-rings.
G) If you are an electric actuator supplier, when you assembling the flange bolts must be screwed symmetrical, gradually and evenly.
H) The cleaner should be incompatible with the rubber electric actuator parts and other special work medium. If the working medium is gas, we can use gasoline to clean metal parts. For non-metallic parts we can clean it with clean water or alcohol.
I) For individual parts we can use dip way to clean. Unlike electric actuators, when cleaning we should remove all adhesion on the surface of grease, dirt, plastic product, dust, etc.
J) If you are an electric actuator supplier, after cleaning we should immediately remove them from the cleaning agent, they should not be soaked for a long time.
K) New parts also need to be cleaned before assembly.
L) We had better use grease lubrication. If the working medium is gas, we can use example of 221 grease.
M) During assembly time there should not be allowed to have metal scraps, fiber, oil (except regulations used) dust and other impurities, foreign bodies, such as pollution, adhesion, to stay on the parts surface or into the lumen.