FLOWX E-mail sales@flowxvalve.com

FLOWX Engineer 86-21-54150349

News

Home >> News >> Industry dynamics >> Instructions for Fixing Door Lock Electric Actuators

Instructions for Fixing Door Lock Electric Actuators

Source:http://www.flowxgroup.com/Update Time:2014-03-01Hits:

The actuator functions the exact same way in reverse to allow automated locking of the front door. Forcing front doors available manually from within or outdoors with the handles bends the rods in the front door. This brings about the actuator to function more challenging to a bent rod and can make the locks stick. Door upkeep can repair sticking door lock electric actuators or it may possibly require substitution from engine worry. Have a query? Get a response from a mechanic now!

Instructions:

1 .Playground the truck and roll the window up totally. Turn the ignition crucial to the "away".

2 .Open the truck front door. Insert a Phillips screwdriver into a screw holding the front door panel on the front door. Turn the screwdriver counterclockwise to loosen and the screw. Repeat this procedure to every single screw from the panel. Draw the panel directly off and arranged it apart.

3 .Spot a single hand on every single facet of the wiring harness for automated house windows. Media the tabs in on every single facet and pull them apart.

4 .Grasp the plastic material dampness defend at the best left and best of the front door. Utilize even soft stress and pull straight down from every single facet. Allow the plastic material dangle by the bottom from the bottom of the front door.

5 .Spray a liberal quantity of lubricating spray on all junctions of the 4 relocating elements in the front door lock electric actuators. These elements are 4 material bars that facet-to-facet or up and straight down.

6 .Straighten any bent rods in the front door by bending them with pliers.

7 .Open the exterior and front door latches to function the lubrication into the joints. Lock and unlock the front door to lubricate the actuator and the lock. Re-apply spray lubrication liberally and permit it to soak for about 3 minutes.

8 .Find the front door electric actuators. It is a little dark box with a yellow clip; the clip attaches a little material rod on the best at the rear of the window observe.

9 .Slide a little, flat screwdriver into the slit on the clip and pull the actuator out. Spot a new actuator into the clip and replace the screw. Tighten the screw in a clockwise immediate.

10 .Media the dampness defends back again into place; smooth it from the bottom up so it will stick to the front door. Plug the wiring harness with each other by pressing the two ends with each other. There is an audible click when it fastens.

Customer Hotline:
021-54150349