FLOWX E-mail sales@flowxvalve.com

FLOWX Engineer 86-21-54150349

News

Home >> News >> Industry dynamics >> How to Change a Hydraulic Filter

How to Change a Hydraulic Filter

Source:http://www.flowxgroup.com/Update Time:2014-04-15Hits:

Do you ever have the desire about how to change filter? If you do, now I can give you some advice about how to change filter.

Hydraulic systems depend on pumps, electric actuators , accumulators, control valves and other devices that need clean hydraulic fluid to operate appropriately. What’s more, we should pumps and valves can become full of contaminants and debris and destroyed important seals in hydraulic components. Moreover, this way can give us a great favor to understand how to change filter. However, hydraulic filters work like any other filters, fluid flows through them, leaving the contaminants trapped within the filter factors. Moreover, filters factors require to be replaced when they become dirty. What’s more, most filter factors are put in a bowl, which must be moved to replace the element.

Firstly, we can depressurize the hydraulic system, which is often done by simply turning the system pumps off.

Secondly, we can pull all circuit breakers that offer energy to the systems hydraulic pumps if applicable. Label the circuit breakers for maintenance.

Thirdly, we can remove any components that block access to the filter, which is the vital essence for us to know how to change filter.

Fourthly, we can cut and remove the safety wire from the filter bowl, if applicable.

Fifthly, we can place a bucket under the filter assembly to fulfill spilling hydraulic oil.

Sixthly, we can move the safety bowl. What’s more, it often unscrews from the rest of the filter housing, and then you must take advantage of a particular filter wrench, but lots of filter bowls have a square surface in order to be gripped by regular open-end wrenches. Knowing how to change filter will help you a lot in your daily life

Seventhly, we need to rock the filter factor out of its housing.

Eighthly, we should install a new filter regulators by pushing into the filter housing, while some filters can be cleaned and reused.

Ninthly, we can replace any O-rings on the filter bowl, and then coat them in hydraulic fluid before installing them.

Tenthly, we can screw the filter bowl back onto the filter housing, and then tighten the bowl to its ideal torque specifications. If we cannot get the torque specifications, we can tighten the bowl as tight as possible without damaging the threads on the filter housing or filter bowl.

After that, we can reinstall any components that are pressurized by the hydraulic system.

And then, we can check the hydraulic reservoir and refill with new hydraulic oil if necessary, and then it's usually beneficial to carry a flashlight to check for leaks, and then press in any circuit breakers that were pulled and turn on the hydraulic system to inspect for leak, and then check the system for leaks, and depressurize the system again before tightening any equipment.

Finally, we can reinstall any other components that were removed for access and remove any maintenance marks from the circuit breakers. All of these steps have been done, maybe we have got much information about how to maintain filter.

Featured Products: pneumatic actuators | sipart ps2 positioners

Customer Hotline:
021-54150349