FLOWX E-mail sales@flowxvalve.com

FLOWX Engineer 86-21-54150349

News

Home >> News >> Industry dynamics >> Electric Actuators System and Automated Facility Control

Electric Actuators System and Automated Facility Control

Source:http://www.flowxgroup.com/Update Time:2014-04-14Hits:

Handwheel development trend requires the electric actuators system to make use of the latch solenoids to control automated facilities in such applications as security ports and irrigation zones. At present, the electric actuators are largely controlled with the use of wired networks and they can communicate with the control center by more than three leads before they carry out the activation or deactivation of the solenoid on the basis of a certain radio link. In some cases, the implementation of the handwheel development trend valve is required, which is normally used for monitoring the nearby environmental conditions and there are other systems that also play a role in the electric actuators working process even though the chargeable battery of these devices are recommended to be replaced on a regular basis so as to ensure that the action of the electric actuators is accurate and in time.

On the other hand, wireless electric actuators networks have distinct advantages compared to previous models since as a rule, they do not require large data transfer rates and more importantly, the wireless electric actuators nodes are powered by super capacitors of small sizes. To be more specific, the design of electric actuators mainly consists of a FLOWX Handwheel development trend part in which the components are intended to optimize the use of the available electric energy.

At the same time, the handwheel development trend firmware have also been taken into account for the optimization purposes in an effort to fulfill the main goal of an electric actuators energy saving layer protocol that requires the devices to identify the main mechanisms of energy cost in detail. This in fact has great importance to the entire electric actuators system since it is about the timing nodes and electric actuators applications. In the case of traditional electric actuators protocols, the signal receivers are in general kept connecting to the information channel so energy efficiency of the device cannot become a priority.

However, this approach is only practical and feasible in low power networks where energy efficiency is a major concern and has become somewhat out of time nowadays when electric actuators network nodes are expected to have power off when they are not working. Apart from the concern of energy efficiency, others reasons such as the need for electric actuators system reconfiguration make the traditional mechanisms not valid in today’s power networks, which is especially true when new approaches have been developed for each type of electric actuators application in particular. By doing so, different handwheel development trend nodes can communicate with each other in a more efficient manner since they enable their signal receivers within the same period of time to work at the transmission mode.

Featured Products: pneumatic actuators | electric valve actuator

Customer Hotline:
021-54150349