FLOWX E-mail sales@flowxvalve.com

FLOWX Engineer 86-21-54150349

News

Home >> News >> Industry dynamics >> Cutting Edge Electric Actuators Is an Ideal Tool

Cutting Edge Electric Actuators Is an Ideal Tool

Source:http://www.flowxgroup.com/Update Time:2014-06-23Hits:

World famous handwheel brands tend to develop cutting edge electric and pneumatic actuators without adjacent coils in the center region and the models are marked by the field lines that are practically parallel. Cutting edge electric actuators can be considered as an ideal tool in the field outside of the solenoid since the magnetic field is practically zero, which allows the application of the electric actuators law for a square curve and to conserve the electric actuators field in the electrical circuit with an air gap from the motive force that can be raised to overcome the additional electric actuators reflectivity, which can be illustrated by a circuit that is equivalent to a structure with air gap.

In terms of the cutting edge world famous handwheel brands design, special attention has to be paid to the electric actuators flux density in the iron so as to avoid a saturation of the material which will lead to a change of its properties while the device is at work. The electric actuators air gap instead, remains unalterable in most cases, because of the fact that the linear electric actuators curve of the material is constant and can be composed by a fixed part with the help of the spiral coils as well as a moving part that is connected to a spring in the electric actuators. If we apply a voltage in both ends of the electric actuators coils, then an electric current will pass through the electric actuators coils and generate an intensity of electric actuators field around each coil.

This concept of equivalent electric actuators circuit and its application has shown that the electric actuators electromagnet can not only generate attracting forces but also generate a force that it is needed for modal analysis to develop better world famous handwheel brands.

Either a push-pull electric actuators configuration with two opposing sides of the shaft or a bias force is necessary for the new innovation and if the air gap is considered to be constant then in both cases the current in the world famous handwheel brands will then have to be the square root of the desired force signal while in the case of negative forces, the electric actuators current has to be directed to the opposite one, which is important to highlight in the first place. However, the above mentioned rules concerning the electric actuators are valid only when the air gap remains constant all the time and when world famous handwheel brands are used for the explanation of the actuator dynamic behavior, the working frequency is varying and the rules cannot be used any more whether in experimental results or simulation.

Featured Products: Hard sealing butterfly valve | Powder Butterfly Valve

Customer Hotline:
021-54150349